RENEMIX has 6 individual channels with a fader potentiometer each. If a signal is patched into the channel you can attenuate its signal. If no cable is patched into the input there will be +5V until +10V available at the output, which of course can also be attenuated. The Voltage Range can be set for all channels equally with the VOLTAGE pot. A channel without a CV input signal can offset other channels of the same group (A or B).  Channels 1-3 are summed at the OUT A jack. Channels 4-6 are summed at the OUT B jack.   All Channels are mixed at the Mix Out Jack. Here you may fade between Channels 1-3 and 4-6 using the A/B Fade potentiometer in the middle of the module.  The overall level or volume can be adjusted with the MIX OUT potentiometer. This Mixer was primarily designed for CV signals, but it can also handle audio.  You will need the RENEPOW Module to power this 0HP Module. Please note the safety information stated in the BOM!   RENEMIX0HP 6 Channel Mixer, Fader and CV Source and Offset


6 Channels Variable Voltage Source +5V until +10V Sub Group (A/B) Output Fade between Sub Groups Wrong polarity protection XU Eurorack module, 0HP Power consumption: 75 mA at +12 V and 46 mA at -12V

The module consists of two boards:

Front PCB Panel Main PCB
Update cookies preferences