Wave V24 HP CV Generator with four connected Triangle LFOs  The rate of each LFO may be adjusted with the dedicated potentiometers. Each LFO signal is supplied on the four outputs on the bottom side of the module. Depending on the potentiometer settings also slopes or square-waves can be generated. Please refer to the demo video below.  The fours LFOs are connected to each other creating an LFO-chain. If the first LFO reaches its highest value, the second LFO starts to rise. And when the first output reaches its lowest voltage, the second channel starts to decrease and so on. Each potentiometer controls the time it takes for the LFO to reach its maximum voltage, which also controls the time it takes to reach 0 volts for its inverted counterpart (1&3 and 2&4). Simultaneously the pots control the time the other two LFOs hold their maximum voltage level.   Patching all LFOs into a VCO´s sound shaping functions you can create wave-like sounding effects that will repeat periodically. This module is very good for generating very slow cycles when the RATE switch is set to SLOW. Conversely, it can also generate fast cycles when the switch is set to FAST.  The state of each LFO is being indicated by the illuminated letters W A V E on top of the module. Each letter will light up when its dedicated LFO outputs a voltage. Details: •	4x LFO Out •	4x LFO Rate •	Rate Switch •	Illuminated Wave-Logo •	Skiff friendly •	Wrong polarity protection •	3U Eurorack module,  4HP wide •	Power consumption: 34 mA at +12 V and 25 mA at -12 V The module consists of two boards: •	    Front PCB Panel •	    Main PCB